Enginemanagementsystem speedometerbulb

fastfun

Supercharged
Joined
Jun 12, 2017
Messages
259
Location
Netherlands
Ride
triumph roadster supercharged, 2010
When one has installed a TTS chargerkit on his bike you have to remove some sensors (i had to) in order getting a fine running engine. Ennoyinging thing is the enginemanagement speedometer light is on constantly. I want to get rid of this light. Is anyone familiar with uninstalling this bulb or taking out some coloured wireconnections to this light ?
 
Last edited:
Thank you but it is not possible to clear this kind of errorcode of the enginemanagement light in the speedometer with tune ecu.
 
fastfun said:
Thank you but it is not possible to clear this kind of errorcode of the enginemanagement light in the speedometer with tune ecu.
Click to expand...
Take a small piece of black tape and fix over the bulb. Problem solved.
 
Not 100 percent on this but u should be able to cut the wire from the ecu to the check engine light.
U spent a lot of time/money installing the tts so why not try to see if u can read codes and see if u can correct the problems. For example sometimes if u remove a sensor u can check the ohms and u can use a resistor to fool the ecu into thinking the sensor is still hooked up.
Of coarse a cut or a piece of tape is easy
 
I removed the secondary throttle plates along with the shaft and stepper motor.
This then threw up a code saying something to the effect of "Stepper motor not present" (I know exactly where it is, it's in my box of bits)
But, back to the point, I have the Engine management light on as well.
I've been told that the later version of Tune ECU has the function to turn this code off.
 

If u plug the stepper motor back in then u should be able to clear codes.
 
You must log in or register to reply here.
Menu
Log in
Register