Search results for query: *

  1. Zonechamp

    Ethanol gas sucks

    Another item to consider is the octane rating. I know in the states you can still buy 85 octane, which is no good in a hemi. Hemi's are recommended to run on 89 octane with 87 being acceptable. Once to really start to work them (especially in hot temps) 87 won't due. The ECU will retard the...
  2. Zonechamp

    Fly screen or windshield

    Flyscreen hands down. I had the stock windshield at 19" and the Clearview 21" with re-curve and they both sucked, a real head shaking experience. Wind up your nose, shirt flying up in the air. I added lowers (2 sets) and fiddled around for months to no avail. I sold everything and put on a...
  3. Zonechamp

    What's your reccomended eyewear?

    I use glasses from Edge. They have multiple styles that come with the foam insert, and the foam can be added to most other models. The Vapor Shield actually works and will not fog. These are the preferred safety glasses in the oilfield in my area. Edge Eyewear
  4. Zonechamp

    Fresh off the Dyno

    I just had my Rocket tuned in Sturgis when I was there last week. What a difference, smooth as can be now. I have the Ramair and CES pipes with a Power Commander V.
  5. Zonechamp

    Stepper Motor Pooched?

    I know my sensor is sitting straight, but I'll have to see if there is a gap or not. I'll recheck my settings in a week or so and see if it moved.
  6. Zonechamp

    Stepper Motor Pooched?

    Well it was the stepper motor. I ordered a new one and everything is working fine. I used Tune ECU off my phone to make sure everything was set up correctly. The new stepper was preset at .72v already, no adjustment required. My TPS was good as well. I don't like the fact that you can move the...
  7. Zonechamp

    How to install Healtech Shiftlight Pro

    Mine is attached to the coil and works fine. There isn't a direct tach output lead on a Canbus system, it's not the same as a old school distributor on a car.
  8. Zonechamp

    Stepper Motor Pooched?

    It idles at about 850rpm when cold and as it gets hot the idle drops down and sometimes stalls out. If I pull the stepper right off, the bike idles exactly the same. I have to track down a laptop and do some more diagnostics on it.
  9. Zonechamp

    Stepper Motor Pooched?

    Everything was set up and tested a few months ago when I changed my primary TPS. I don't have a laptop right now so I tried to check it with my Android, and everything checks out.
  10. Zonechamp

    Stepper Motor Pooched?

    It powers, but it doesn't move at all, at any time. That's why I was trying to figure out if it was the stepper or the TPS and associated wiring that makes it move. I really think it's the stepper as the TPS is set correctly. Thanks for the info.
  11. Zonechamp

    Stepper Motor Pooched?

    My stepper motor does not move at all during startup. I reset all the perimeters and everything seems to be in spec. My question is, should I be able to move the shaft by hand at all? I can't budge it. Also is there a way to jumper it to make it activate so I can see if it moves or if it's seized?
  12. Zonechamp

    How to install Healtech Shiftlight Pro

    Nope, straight forward installation. Connect to the coil wire as pictured above. I glued the mount to the inside of my flyscreen so the light showes above my T-bars. I also wrapped the whole unit with electrical tape to keep water out. Works great.
  13. Zonechamp

    How to install Healtech Shiftlight Pro

    Yep you bet. It's not as bright in full daylight as I thought it would be, but still easily seen. I wasn't really thinking this through when I ordered it. I didn't get the blue because blue at night is hard on my eyes, but I should have realized that it's never really on is it? It's not like a...
  14. Zonechamp

    Always thought my Rocket was a big bike until...

    My other bike is a KLR 650, and for sure an adv bike is way taller and looks wider because of the handle/crash bars. Of course I am a little short on HP with the KLR, I have 42 to be exact. Still fun to rip around on.
  15. Zonechamp

    How to install Healtech Shiftlight Pro

    Thanks for the info. I just installed a Raptor Performance shift light and it works perfectly. Hopefully it will aid in making the 1-2 shift actually happen on time. ;)
  16. Zonechamp

    Foward controls

    If you are getting the FC-17 controls, make sure you are getting the revised edition with the extra gussets. The first release controls are junk, they flexed bad and are not safe. I have a post on here with pictures.
  17. Zonechamp

    What did you find when you adjusted your valves.

    I just had my valves adjusted and I have 42,000km on my Rocket. The dealer had to adjust 10 out of 12. I should have done it sooner I guess. I don't have the sheet handy right now, I'll see if I can find it.
  18. Zonechamp

    CES installed!

    No doubt. I know there is a HP/weight ratio somewhere, but 65lbs should be equivalent to roughly 8hp.
  19. Zonechamp

    CES installed!

    Not to mention I lost 65lbs this winter, so that will add even more zip. Riding my Rocket will be a whole new experience this year, I can't wait.
  20. Zonechamp

    CES installed!

    I have the same pipes in black with the heat shields. With the pipes, Ramair, removal of the secondaries and a dyno tune I am up 41hp at the rear wheel. Still waiting on spring for a full road test.
Back
Top