Search results for query: *

  1. Rear Shock Mount

    If the pin wont come out then maybe grind it off past where the tap is inserted then drill and extract out of the housing? Mal

  2. Rear Shock Mount

    Thanks Val. have been on nights so its all blurred! do you mean tapped into the shaft housing? The tap i have snapped off was trying to sort the outer bolt i havn't tried to remove the pin from the housing as of yet. Mal

  3. Rear Shock Mount

    Am hoping this is the case. tried to tap as suggested but used a cheap tap and it snapped and is very reluctant to come out and have tried! If its threaded in which when i look at it is a possibility then hopefully easier job, will give triumph a call tomorrow about ordering a new mount post...

  4. Rear Shock Mount

    Hi All, is it possible to remove and replace the shaft shock absorber mount? had a thread problem and now i think it needs replacing. Mal

  5. Running On Two!

    Thanks for the replies, This is where i am at now....replaced coil on non firing cylinder managed to fire it up still only on rear 2 cylinders, Managed to get codes on tuneboy P0351 Ignition coil 1 circuit malfunction P0352 Ignition coil 2 circuit malfunction even with the second code that...

  6. Running On Two!

    Think coil seems to be the way to go. will check leads earth etc but with one plug showing weak spark the consesus on r3.com seems to be plugs not sparking under load due to bad coil. so wkend i will go down that route see how i get on.

  7. Running On Two!

    Hi all here's my problem with my 2006 classic,had the bike running until it was warm,switched off then on restarting it front cylinder not running. I have checked the spark and all ok,battery is new and fully charged,all hoses seem tight and good,filters clean, petrol good,took plugs out they...
Back
Top