Kiwicol's latest activity
-
Kiwicol replied to the thread Bevel Box circlip.Well, according to the pic, the bearing is in there, then the seal and then the circlip, on the outside of the seal. It's not like that... -
Just been looking at the parts diagram and I see there is a circlip (Part 11) in with the needle rollers. I've not seen this, I'd...
-
-
Kiwicol replied to the thread Quickshifter.My scan tool can activate and deactivate the TSA. plus heaps of other 'dealer only' functions, like key coding service light reset...
-
Kiwicol replied to the thread Quickshifter.With a voltage drop like that I'd say the TSA just need to be relearned. Ya get the same thing when you disconnect the battery, the...
-
You'll find that for every part that has any kind of Loctite on it that Triumph says to replace the part. The three bolts holding the...
-
Kiwicol replied to the thread Lube the splines....That mushroom one above is exactly how it is.
-
-
I would feel better double locking regular nuts on studs that were locktited and installed in housing with correct torque, then removing...
-
Kiwicol replied to the thread Lube the splines....Haven't taken the bike for a proper test yet, maybe tomorrow, but there's a correction from yesterdays 'advice' re stud and cap. Well...
-
I don't think it comes with the nut since its not listed as coming with the nut and when you look up the diagram for the stud, it never...
-
Kiwicol replied to the thread Lube the splines....I was told the part number T3201277 is a Stud: M12 ENC SLV. The ENC part stands for encapsulated and the SLV stands for Silver. I'll...
-
Kiwicol replied to the thread Lube the splines....I went off looking for possible replacement studs (T3201277) and I noticed the cap nut wasn't on the list of parts. I then find out...
-
-
Kiwicol replied to the thread Lube the splines....Some more pic's of the jig in case anyone is interested.
-
-
Kiwicol replied to the thread Lube the splines....Took it for a wee ride down the road, just to make sure I'd done everything up and to check for the noise. Only go to about 30kph and no...
-
Kiwicol replied to the thread Lube the splines....Thanks guys. i cleaned up the studs and put some blue loktite on them. Went back together in about 3 minutes by myself. That jig holds...
