How does the Roadster peg position compare to the Tourer footboards position? I swapped the Tourer footboards, heel-toe shifter and kick stand onto my '07 Standard (very pricey!) and they work perfectly.
Too much risk to ask someone to take
I just finished the torsional damper shaft bearing replacement on my '07 R3 with less than 10K miles on it. They literally had to tear the bike apart to do it. I have pictures of the bike hanging from safety straps with nothing but the fork and the...
I had what sounds like a problem similar to several of the posts on this thread - revs would stay 1800-2000 and would not return to idle. It turned out to be a low tech issue. The twist grip was binding on the bar end weight and wouldn't allow the throttle to return to the idle position.
tranny bearings gone-QUESTION
My 07 Rocket with 9900 miles on it is in the shop for replacement of the damper shaft bearings. So far, Triumph has said they will send the parts kit at their expense, but labor to install would be on my dime. My dealer has made the very fair offer to absorb half...
I just bought a set of Hepco Becker hard bags. I haven't mounted them yet but they look great and are top quality. They are the only maker I found besides Corbin that makes a mounting rack specifically for the R3.
You sure that doesn't say Checker on it somewhere?
Actually, great bike. I've put a lot of miles on rented Wings (including yellow ones) and enjoyed every mile. Good luck with it.
I always thought the vests were a practical thing. If you sew your patches to your jacket, every time you get a new jacket you have to pull them off the old one and and sew them on the new one.