Recent content by biker1059

  1. biker1059

    Triumph ROCKET 3R - starter

    That was my first thought, cross reference and find a cheaper version of the same thing. That's awsome
  2. biker1059

    Video on greasing the drive shaft splines.

    Thank you!
  3. biker1059

    2020 'R' model rear brake disc

    Sorry I did not update my trip to the dealer. They replaced the springs (washers) and no more noise or play in the disc. They did say that it was ok for the disc to move that freely but I disagree. Anyway I am happy with the results
  4. biker1059

    Question about pannier speed limit

    Been 130+ MPH indicated by speedo several times with no problems
  5. biker1059

    Front tire removal.

    I found it easier to remove the front fender instead of the brake calipers. With the fender removed the wheel slides right out.
  6. biker1059

    2020 'R' model rear brake disc

    Just took my bike in to the dealer for a dash update and have had the same rattle noise for some time. The tech said the springs were worn so bad or completely gone. He described the springs as a wavy washer that holds the disc tight and said they were about a $1.50 apiece. The disc has alot of...
  7. biker1059

    Evotech LED Scrolling Signals

    Update: Took bike in to the dealer today and they performed the dash update and everything works great. These signals really look good.
  8. biker1059

    How much do you pay for insurance for 2500cc?

    $425. 00 a year full coverage Texas
  9. biker1059

    Evotech LED Scrolling Signals

    will do, also the 2 bolts are 3mm hex head. And it's so much easier to take the license plate off and remove the 3 bolts which are torx head and then there are 4 more torx head to remove the mud guard. Seems like more work but it will save you lots of time
  10. biker1059

    Evotech LED Scrolling Signals

    How do you figure out what resistor to use? That seems like the easiest option for me
  11. biker1059

    Evotech LED Scrolling Signals

    There are two bolts under each blinker and that separates the blinker housing. Then look between the back mud guard and the bottom of the blinker housing and there are two more bolts mounted horizontally, Those two are a ***** which are the ones that will tighten the whole housing.
  12. biker1059

    Evotech LED Scrolling Signals

    I tried the wiring both ways thinking that was the problem but no luck it was even worse. I'm almost certain I had the wiring right
  13. biker1059

    Evotech LED Scrolling Signals

    That's what I was thinking, it hasn't been updated in a while
  14. biker1059

    Evotech LED Scrolling Signals

    can't seem to get mine to work either the front blinker comes on and hyper flashes or sometimes the rear will hyper flash. Best mine has done is blink 3 times correct and then stop all together. Did you have to do anything special to get yours to work? BTW mine is a 2020 GT if that matters
  15. biker1059

    Evotech LED Scrolling Signals

    What year model on the Trident? Never mind I think they are all the same Thanks for the info just ordered a set. Don't like the round lights either.
See more
Back
Top