Search results for query: *

  • Users: Pilvi
  • Order by date
  1. Pilvi

    Tweeting my riding position.

    Done.
  2. Pilvi

    Tweeting my riding position.

  3. Pilvi

    Tweeting my riding position.

    Howdy from Finland. I´m planning to to make ape hanger for my 2005 stantard Rocket. 1 1/2" tube with standard controls and heated grips. I´ll route wires trough bars, bar height might be 16"-17" (I´m 6´7" tall with long reach). Any toughts? Do I need to extend wires? Which type are the ends in...
  4. Pilvi

    Where's a good spot to relocate the air temp sensor?

    Have anyone had problems because of the location air termp sensor. I had wiring so short that sensor is between frame tubes above the engine. After installed K&Ns there´s been mysterious cut off´s and jerks, can this be due to hotter location?
  5. Pilvi

    How to Install Triple K&Ns Under BearClaw

    Hi! Installed K&Ns last spring. Question about air temp sensor, what to be expected if left under tank without it being in airflow?
  6. Pilvi

    Heat-related problem

    Howdy, I have a mysterious problem. hard to explain but I give it a try. Problem is a bit like the one disgussed in this thread. I Changed the triple K&N´s, and since then there´s been like choking effect while driving. Bike chokes and spats (backfire?) and dies with jerk, if there´s enough...
  7. Night ride 2005, Finland

    Night ride 2005, Finland

    New bike on a test run at night 2005.
    • Pilvi
    • Media item
    • Comments: 0
    • Category: Member Galleries
Back
Top