Search results for query: *

  1. Chris Lett

    New member

  2. Chris Lett

    New member

    Thanks
  3. Chris Lett

    New member

    Finally got time. Pulled all the electrical connectors apart sprayed contact cleaner Put new gas in tank. Fired right up. Apparently low fuel signal kills fire. Oil became milky in less than 3 minutes. Drained refilled tried again got milky right away. I guess I’ll keep draining then short run...
  4. Chris Lett

    New member

    Ok, got a little time, installed a heavy ground wire from battery to exhaust pipe bolt at head, jumped ground to coil- fires, disconnected tip over switch- cranked 7 cycles no luck, plugged tip switch back up, tried again no luck, tried with side stand up. Saw a thread that mentioned relays...
  5. Chris Lett

    New member

    I have tank removed. But pump did run for short bit when key on. I found flywheel sensor next to starter. Dirty, cleaned it. Haven’t found cam sensor yet. Cleared codes, only one returned is low fuel. i do have 12v at coils couldn’t tell much with digital meter regarding ground at coils. Need...
  6. Chris Lett

    New member

    I haven’t checked coils or injectors yet. I did hook up a cheap harbor freight OBD scanner. Got codes P0460 low fuel, P1500, P1552. So looks like ecm ok. Fuses all ok. I guess I need to check crank and cam sensors. Would low fuel code shut down fire and injectors?
  7. Chris Lett

    New member

    He drained within a day. Lights, horn, fuel pump, starter all work. No spark, dash lights. Dash lights flash when cranking. I assume ECU shot.
  8. Chris Lett

    New member

    Just purchased an 07 R3 flood victim hoping to restore.
Back
Top