Recent Activity

Activity stream for all registered members at R3Owners.

  1. scot in exile attached a file to the thread New tyres on my 2014.

    I thought that was not a bad price for four new tyres:D oops did I forget to mention they were for my van:banghead: [ATTACH]

    GJ2ZdLqAQPOpJQkRdqdhtA.jpg May 25, 2019 at 6:34 AM
  2. Gregger replied to the thread How screwed am I?.

    I bet you these T Slot bolts (or something similar) are used in that application. They are dropped into the retainer plate slot then...

    May 25, 2019 at 6:20 AM
  3. Gregger liked scot in exile's post in the thread How screwed am I?.

    Torque wrenches are great tools when used correctly:eek: i use my torque wrench for most jobs but I felt that hand feel was best when I...

    May 25, 2019 at 6:08 AM
  4. Sensfan replied to the thread How screwed am I?.

    I have never had a problem drilling out snapped bolts with left hand thread drill bits. Comes in a kit of six bits,start with the...

    May 25, 2019 at 6:05 AM
  5. Gregger replied to the thread How screwed am I?.

    The only issue with this is the fact that the leak may not show itself until you get a few mile on the bike. You then have fuel...

    May 25, 2019 at 6:05 AM
  6. wsk3 liked barbagris's post in the thread Comparison of 12 separate 7-inch LED headlight reflectors..

    Lumens - OK is that RAW or EFFECTIVE. I can attest to the Truck-Lite having a very precise intense beam. Very little scatter. This in...

    May 25, 2019 at 6:03 AM
  7. phar2slo liked Y62's post in the thread How screwed am I?.

    Its only two and not next to each other, assemble and test.

    May 25, 2019 at 6:02 AM
  8. phar2slo liked Bob R's post in the thread How screwed am I?.

    They are studs that stick up through a metal piece. A bit of a bump, not sure I can get under there to replace them. it was Nm. :( bob

    May 25, 2019 at 6:02 AM
  9. phar2slo liked scot in exile's post in the thread How screwed am I?.

    Torque wrenches are great tools when used correctly:eek: i use my torque wrench for most jobs but I felt that hand feel was best when I...

    May 25, 2019 at 6:02 AM
  10. phar2slo liked ToledoBendTom's post in the thread How screwed am I?.

    No judgement, but was torque wrench inch or foot lbs. Try an easy out to drill them out. If you can’t find all stock in right size,...

    May 25, 2019 at 6:01 AM
  11. Gregger replied to the thread How screwed am I?.

    That's exactly what I would do. I don't even think they are studs. They look like metric bolts with shallow hexagonal heads. Cut...

    May 25, 2019 at 5:58 AM
  12. Gregger liked scot in exile's post in the thread How screwed am I?.

    A Dremel tool cut slots remove the busted ends replace with new studs with a washer

    May 25, 2019 at 5:54 AM
Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice