RockOn's latest activity
-
RockOn replied to the thread Torx Hatred.One of those occasions when sometime in the past I had stocked up on stainless Allen head M6 screws and lock washers and found them... -
-
Run the correct thread tap through hole to see if hole/thread will hold, if not drill hole to the next size for next larger screw and...
-
If you have trouble posting, it's usually due to not being logged in. Happens sometimes when you reboot your computer.
-
You can see if the thread pitch is correct by placing the new screw ontop of one of the original screws if you have one. They should...
-
Yes that is ok When you get the tap lay one of the bolts on top of the metric tap to see if is the same thread.
-
RockOn replied to the thread Torx Hatred.Yes, could not post, not logged in, which surprised me. Not trying to change threads from an M6 1 X 12mm which is what my search says...
-
RockOn replied to the thread Torx Hatred.Maybe I could not upload photos because was not logged in? Will try again.
-
-
RockOn replied to the thread Torx Hatred.
-
RockOn replied to the thread Torx Hatred.Long story, short version, got the screw/bolt out after using my extractor kit. Accidently drilled all the way through the screw with...
-
Crank the air pressure up over 100 psig and first drive in a little and then reverse it, see if that gets it moving.
-
RockOn replied to the thread Torx Hatred.That's a thought, seems to me I may have one buried somewhere in my garage. I tried my manual hand-held impact driver yesterday and...
-
I'm with you, I hate Torx, it's total garbage. Each time I have to remove one, it gets replaced with an allen / cap / button head bolt...
-
The cats are in the massive mufflers. I replaced my mufflers and cross over with Dave Platt stainless.
-
That freeze off penitrating oil actually works pretty good, key is to keep spraying it for a good bit you let it get cold so use a rag...
-
RockOn replied to the thread Torx Hatred.Ok, will give that a go first. If no go, then Dremel an X and use my impact driver. Good grief. I'm too old and lazy for this SH*T!
