eka's latest activity
-
They have ones that will screw right onto the grease gun also. FYI Milwaukee makes a nice 12v grease gun, I'll never use a manual one again. -
eka replied to the thread Wilbers competition 643 Install.I ordered with 15mm height adjustment and after about 20 000km the preload hose broke. I think it was a bit too short for that and...
-
-
eka replied to the thread Eka's Pretty TuneEcu Maps.AI says: Of course more you take out, the more you stress the engine, but isn't it just the point to tune anyway. I had 20 years ago...
-
-
eka replied to the thread Eka's Pretty TuneEcu Maps.I have not had this bike at dyno to adjust perfect fuelling, but i assume my maps are pretty much on rich side. Penner tune is also...
-
eka replied to the thread Eka's Pretty TuneEcu Maps.I have crossed it to detonate few times in certain areas when trying to find the limits, but right away backed up few degrees. At least...
-
-
eka replied to the thread Asymmetrical front tire wear.I think all my bikes has worn tires more at right side...not just Rocket with wonky geometry and longitudinal engine. At right side...
-
getting ready to fit some Exedra's on. I got about 8k miles out of the original Chromes. So being 55 series tire on the rear I wanted...
-
eka reacted to Claudiu's post in the thread Rebuilding motorcycle after timing chain skip 62K Km with
Like.
Cleaned pistons -
eka replied to the thread Eka's Pretty TuneEcu Maps.I forgot to say that center cylinder runs hottest, rear one a bit colder and front one coldest. I made spreadsheet and tested a bit. I...
-
eka replied to the thread Eka's Pretty TuneEcu Maps.And of course there is more fuel where is more advance. Tuned fuelling for original ignition map: My iterated pretty fuelling map:
-
-
eka replied to the thread Eka's Pretty TuneEcu Maps.Yes, in higher load advance should be less. I iterated different angles and caps and this map was the best i found. At lower revs it...
-
-
eka replied to the thread 2022 Triumph Rocket3 Gt.I am couple kgs heavier and measured that rear suspension sacks a bit over 4 cm when preload is fully tightened. It is too much...
-
I have a bad habit to reprogram ECU all the time and try this and that. I just noticed, that i have reprogrammed ECU over 100 times and...
-
eka replied to the thread Customised seat myself.I did like original R seat. Never got sore butt, but my knees were a bit stiff after long rides. I have aftermarket pegs higher than...
-
-
eka replied to the thread 2022 GT Grip Question.
-
