Recent content by Dyna494

  1. Rocket 3 Inner Pannier Bags

    Unfortunately Triumph have withdrawn their inner pannier bags part number A9510082. Doe anyone know of a company that makes shaped inner bags for the standard rocket 3 leather panniers. Or does any one have any for sale? Thanks in advance.

  2. Embarasing No Start - Plugs Fouled

    Went to a funeral this week. Did a bit of a tour and rode about 700 miles to get there. Hundreds of bikes met up and when everyone set off to the church mine would not start....... It would run on two cylinders if I gave it some revs but would not tick over. Got the bike back to my...

  3. Fuel light comes on too early

    I hear this is not uncommon. My fuel light comes on when the tank is about half full. I bent down the float arm but this made no difference. I bent the float arm down some more but this also makes no difference. Correct me if I'm wrong but I'm told this is the theory: There is a plate...

  4. Progressive Springs - How Much Oil?

    The Triumph dealers want me to take my fork legs in and said they can finish the job for £40 - £50. You need a special too to re-fit the springs after you have measured the air gap withthe forks semi assembled. As long as the oil is virtually the same in each fork leg, just how critical...

  5. Progressive Springs - How Much Oil?

    Thanks but unfortunately the Triumph dealers can only quote standard parts and standard information quoted in the manual.

  6. Progressive Springs - How Much Oil?

    If nobody knows or can't find out I'm gonna try slightly more that the standard 667ml and put in 675ml then see how it feels when I ride it.

  7. Progressive Springs - How Much Oil?

    With so many people changing to progressive shocks someone must have measured in the fork oil??????????

  8. HAGON NITRO vs Progressive 440 vs Progressive 430 vs Other

    I got nitors with stainless springs but agree they would look better in black. Hagon do nitros with black coated heavy duty springs but they aren't stainless steel. Was thinking of getting mine powder coated.

  9. Progressive Springs - How Much Oil?

    Did any one measure how much fork oil you put in when changing to progressive springs? Does anyone know how much oil to put in or can anyone work out or guess how much for oil leaves an 80mm air gap?

  10. Progressive Springs - How Much Oil?

    I don't have the over priced triumph tool but I stripped down my forks and fitted progressive springs to the internals. Without the special tool I cant compress the forks with no springs fitted and measure the air gap that progressive say should be 80mm. Did any one measure how much fork oil...

  11. Changing Clutch Plates Help

    OK here we go...with your help. Clutch plates and recently acquired lifter piece fastened in. bolts with new spring nipped up snug but not too tight. The lifted piece has a bit of play and can move in and out about 5mm. Is this correct? The lifter shaft in in the engine casing with the...

  12. Changing Clutch Plates Help

    I spoke to Richard at TTS Performance, he says he has seen over half a dozen of these button heads pulled off the lifter piece. It's a common fault. He said they once fitted a new clutch and fitted the actuator arm in the position where you think it should go but it was too far round and...

  13. Changing Clutch Plates Help

    The new spring are 10% heavyer that standard. I put the bolts in evenly and nipped them up. Is there a specific torque setting that I should tighten the bolts to?

  14. Changing Clutch Plates Help

    Thanks. Its a late 2004 model. After I did a burn out the biting point went way out on the lever and the clutch was slipping even with the lever fully out. After installing new friction plates and springs I pulled out the lifter piece slightly so that the lifter shaft could hook under the...

  15. Changing Clutch Plates Help

    Any ideas??? Any one?????
See more
Back
Top