dd14x's latest activity
-
That’s the one, it’s the same OBD port style that cars have, so your OBD reader plugs straight in (see my pics from page 1) with no... -
dd14x replied to the thread Evotech LED Scrolling Signals.Thank you both! I will give it one more shot this week - else I'll have to go to the dealership - worried I'll strip those
-
will do, also the 2 bolts are 3mm hex head. And it's so much easier to take the license plate off and remove the 3 bolts which are torx...
-
I believe they are 3mm allen head. 2 under the turn signals and 2 on the back. Everything has loctite so it may seem tough at first. I...
-
dd14x replied to the thread ODB port 2020 Rocket 3.My bad for resurrecting an old post - I was just trying to locate the OBD port under the seat - only see the large 20 pin port and have...
-
dd14x replied to the thread Cleaning metal parts?.I applied a ceramic coat to the aluminum bits when I coated the rocket. Didn't think of lacquer - will have to give it some thought :)
-
dd14x replied to the thread Rear turn indicator loose.Nah - the splash guard was easy to get to since the screws face towards the back (not towards the wheel)
-
It's only 3 M8 (I think) Allen head bolts. I didn't disconnect the wiring but it definitely made it easier to see everything. I lay it...
-
dd14x replied to the thread Rear turn indicator loose.You are right - that would definitely make it easier. Not sure I feel confident enough to try that (esp with travel tomorrow). Will try...
-
dd14x replied to the thread Evotech LED Scrolling Signals.What size are those 2? I can't get any size to fit there
-
There are two bolts under each blinker and that separates the blinker housing. Then look between the back mud guard and the bottom of...
-
dd14x replied to the thread Rear turn indicator loose.I cant figure out how to remove the top cover... There are 2 hex heads behind the reflector (facing the tire) - supposedly M5 - but I...
-
-
The original bolts are too small... you need like a 1/8 more. I replaced mine after exhausting my limited bad words vocabulary trying...
-
Remove the allen bolt and inspect the threads on the mounting point. If they are galled or stripped that's a whole other problem than...
-
I think the most likely scenario is someone loosened it to change or remove it and it's after coming free from the fastener inside. I...
