dd14x's latest activity

  • dd14x replied to the thread Cleaning metal parts?.
    I applied a ceramic coat to the aluminum bits when I coated the rocket. Didn't think of lacquer - will have to give it some thought :)
  • dd14x replied to the thread Rear turn indicator loose.
    Nah - the splash guard was easy to get to since the screws face towards the back (not towards the wheel)
  • dd14x reacted to ciderbaby's post in the thread Rear turn indicator loose with Like Like.
    It's only 3 M8 (I think) Allen head bolts. I didn't disconnect the wiring but it definitely made it easier to see everything. I lay it...
  • dd14x replied to the thread Rear turn indicator loose.
    You are right - that would definitely make it easier. Not sure I feel confident enough to try that (esp with travel tomorrow). Will try...
  • dd14x replied to the thread Evotech LED Scrolling Signals.
    What size are those 2? I can't get any size to fit there
  • dd14x reacted to biker1059's post in the thread Evotech LED Scrolling Signals with Like Like.
    There are two bolts under each blinker and that separates the blinker housing. Then look between the back mud guard and the bottom of...
  • dd14x replied to the thread Rear turn indicator loose.
    I cant figure out how to remove the top cover... There are 2 hex heads behind the reflector (facing the tire) - supposedly M5 - but I...
    • 1000038491.jpg
  • dd14x reacted to pica's post in the thread Rear turn indicator loose with Like Like.
    The original bolts are too small... you need like a 1/8 more. I replaced mine after exhausting my limited bad words vocabulary trying...
  • dd14x reacted to atomsplitter's post in the thread Rear turn indicator loose with Like Like.
    Remove the allen bolt and inspect the threads on the mounting point. If they are galled or stripped that's a whole other problem than...
  • dd14x reacted to ciderbaby's post in the thread Rear turn indicator loose with Like Like.
    I think the most likely scenario is someone loosened it to change or remove it and it's after coming free from the fastener inside. I...
  • dd14x replied to the thread Rear turn indicator loose.
    Ok - so there is a nut inside the plastic that is holding that screw in?
  • dd14x replied to the thread Evotech LED Scrolling Signals.
    So, um, how do you remove the rear indicators? Mine is loose and I can't tighten or loosen it...
  • dd14x replied to the thread Rear turn indicator loose.
    Thank you - I've been trying to loosen that, but it just keeps spinning in place - is there a nut within the plastic?
  • dd14x posted the thread Rear turn indicator loose in 2.5 Litre Rockets.
    Not sure when, but somehow, my rear left turn indicator (2025 storm GT) is loose. Guessing somebody bumped into it at the parking garage...
    • PXL_20250510_173503128.MP.jpg
    • PXL_20250510_173518751.MP.jpg
  • dd14x replied to the thread ODB port 2020 Rocket 3.
    Is it the 16 pin OBD2?
Show older items
Back
Top