Recent content by Cor

  1. Cor

    For Sale 2010 Carpenter Racing R3R For Sale - Thread revival!

    What did this bike run you? If you don't mind me asking?
  2. Cor

    TPS or stepper

    I have to thank you bro. So it seems I've sorted out the problem. I did a tps/iscv reset. Put the voltages at .62 and .72/.73. After that I copied the (N) table thanks to your insight off the 20355 tune that my bikes dyno was based off and reloaded the tune from the dyno with that reworked (N)...
  3. Cor

    TPS or stepper

    It has a ram air, a viking 3 to 1 exhaust. Not cat, but does have 02 sensor.
  4. Cor

    TPS or stepper

    When I plugged in the cable to the bike I did read map and this is what it downloaded. But yes prior to me using the read map feature it was made on a dyno. If you look under Kalsaint profile it was his bike he had dynod in Melbourne Florida.
  5. Cor

    TPS or stepper

    So the map from the dyno tune is the only one that has a poor idle upon cold start. If I hold throttle and it warms up, the idle works itself out. If I posted the map from the dyno would anyone be willing or able to adjust it and send it back? You may be able to see exactly where the issue is...
  6. Cor

    TPS or stepper

    Got ya. Mine is a 2011 and once I changed to a different tune all the tunes seem to start ok and idle fine. When you reload a new map does that reset all the sensors including tps and iscv? Basically should I try reloading that map and see if it sorted itself out? I'd like to use the dyno tune...
  7. Cor

    TPS or stepper

    What did you do to fix the issue, id like to know. Thanks
  8. Cor

    Stalling

    Hey what did your issue end up being?
  9. Cor

    tune 20355

    Thanks, will do. I'll keep ya posted. 👍. And no I don't have a power commander.
  10. Cor

    tune 20355

    Awesome thanks a lot bro 🙏
  11. Cor

    tune 20355

    Here's the dyno of my bike btw if anyone wants to take a peak and leave any suggestions. Like I said on this it was idling hard almost stalling out until warm and quite a bit of popping. Minus those two things it ran we though.
  12. Cor

    tune 20355

    Hey I tried that viking map you sent and it was honestly I feel like the best one so far. Still an occasional bing pop/bang from exhaust. Runs pretty hot while not cruising. Any of those other viking maps in you saved files worth a try? Of so send em my way of gou don't mind. 👍
  13. Cor

    tune 20355

    Feel like with my little knowledge I'm bound to mess it up. Also do my symptoms sound like I may need to adjust the tps and iscv like John and Martin discussed. Thanks
  14. Cor

    tune 20355

    Here's a questions for anyone. I could post the dyno tune from using "read map" when I got my cable. If I posted that tune here would anyone be interested with editing it and sending back to me. Like I said it pops when decel and also idles rough and almost stalls out. Lmk
  15. Cor

    tune 20355

    In your opinion does that look like a usable map for the settup i described. What catches and stumps me a little about this tube is the L tables look so strange.
See more
Back
Top