Uncorked a little more. Today's dyno

Bob R

Living Legend
Joined
Jul 30, 2012
Messages
2,071
Location
Pahrump, NV
Ride
2013 R3T
This was an apple to apples dyno run.

Same bike, same tuner, same dyno, **** near the same conditions.

Old run 96 degrees@ 9% humidity

Run today 91 degrees @ 19% humidity.

The only change made was swapping out the all of the stock air stuff for a Ramair and relocating the overflow bottle to the empty airbox. Both runs were made with TORS installed.


Old numbers Max power 120.9 Max Torque 145.45

New numbers Max power 132.1 Max Torque 148.07

Just a quick picture of the old and new numbers. I will scan later. Old numbers in blue, new numbers in red.

Bit, all in all I am very happy with the Ramair.


Dyno sept.jpg


:D


bob

sdit. There was a 1.5% difference in indicated speed between the Metlers and the Bridgestone Exedera Max I am now running. Even tweaked that, now 80mp is indicated 80 instead of 78ish.
 
Nice HP gain, Bob!
Likely that Ram Air.
How's young Nels doing?
 
Nice power gain. How was the bike set-up on original run.
The only difference between the two runs was about 18 months and it now has a Ramair in place of the stock air intake system. Other than that no changes.

Bob
 
Dynotest.jpg
Mine was similar, 11hp gain from stock to pods but then got additional 5 with dyno tune. That was awhile ago now.
 
No it isn't, not too shabby at all. Even better, I picked up the filter here for less than the cost of new, even though it was new.:D

bob
 
Back
Top