License Plate Holder

[goncallf]

Hi guys,

I need your help. My Rocket has a homemade license plate holder, but the way it is assemblied, compresse to much the inside fender struture. As you can see in photo below the bottom of the rear light has a gap because of that.


In order to see how the OEM license plate holder is assembled, can someone take some photos and post here of the OEM inside fender?

Thanks

 

[Dawg68]

Hope this helps,

 

[Dawg68]

Used a flash this time

 

[goncallf]

Thanks Dawg68

 

[Mittzy]

I can send you the bare one at cost of shipping if you need it.

 

[Mittzy]

Post is AUD $54.77 to Portugal

 

[goncallf]

Post is AUD $54.77 to Portugal

Thanks Mittzy, but i think i can get a new one for 32€ which is more or less the same for the shipping from AUD to Portugal. If I need it I will contact you

 

[goncallf]

Hi Mittzy

Can you tell me the measures above:

 

[Mittzy]

Hi Mittzy

Can you tell me the measures above:

Sorry for the delay. I had packed it away so I had to dig it out again.