K&N Filters

Discussion in 'BearClaw Corner' started by Paul Bryant, Feb 20, 2018.

Tags:
  1. Paul Bryant

    Paul BryantTop Fuel

    Country:
    New Zealand
    Messages:
    1,840
    Featured Threads:
    26
    Likes Received:
    3,612
    Trophy Points:
    323
    Location:
    Hamilton. New Zealand
    Ride:
    2006 Rocket
    Would some one give me the K&N part numbers/sizes for the two other small filters that go on the Air temp sensor and the Crank Case breather please.
     
  2. Tal

    TalNitrous

    Messages:
    1,359
    Featured Threads:
    12
    Media:
    2
    Likes Received:
    2,403
    Trophy Points:
    223
    Location:
    Christchurch, New Zealand
    Ride:
    2016 Triumph Rocket Roadster ABS A2
    Think they are just a small 12mm filter Paul which you can get from Repco or Supercheap. I put one over the bulb on the AIT sensor and plastic tied it between the 2nd and 3rd K&N pod on the throttle bodies. Also put one on the crankcase breather hose.
     
    Paul Bryant likes this.
  3. WyldCFH

    WyldCFHDrop a gear and disappear

    Country:
    United States
    Messages:
    1,288
    Featured Threads:
    6
    Likes Received:
    1,431
    Trophy Points:
    223
    Location:
    Pembroke Pines, Florida
    Ride:
    '16 Rocket III Roadster
  4. gR3yWolf

    gR3yWolfSupercharged

    Country:
    United States
    Messages:
    229
    Featured Threads:
    3
    Media:
    2
    Likes Received:
    185
    Trophy Points:
    53
    Location:
    Johnstown, PA
    Ride:
    '07 Classic
  5. 1olbull

    1olbullRiding Motor Since 1951

    Country:
    United States
    Messages:
    17,901
    Featured Threads:
    90
    Media:
    5
    Likes Received:
    12,800
    Trophy Points:
    823
    Location:
    Tacoma, WA
    Ride:
    2012 R3R - 1980 Honda Twinstar - 2018 Yamaha XT250
    Pablo,
    Tis a female dog trying to install that crankcase filter - one that you'd also have to endure every time you clean the sucker!
    I opted to plug the large oval into the air box from the engine side.
    I then covered the entire floor of the box with a good foam covering that allows air access while keeping the box clean for all my tools & ****h.
    Clean it once a year - works perfectly for me and I do ride some dirt roads . . .
     
    Paul Bryant likes this.
Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice