Idle hanging high

hoopla

Mained to ride!
Joined
Jan 21, 2017
Messages
1,178
Location
Maine, USA
Ride
2022 Rocket 3 GT
I recently installed PCV and AT, which has resolved my popping issue, however at about the same time, my idle hangs around 1500 rpm until the clutch in pulled in.

So when I down shift from any gear, the idle fails to retreat to 900 rpm. As soon as the clutch is pulled in it drops. I've checked the TPS and it reads .60v and the ICSV is .71v.

My set up is Ram Air, DP cross over pipe, and TORs.

Thanks

Hoopla
 
While the voltage spread is right...I would go ahead and do an ISCV reset, and then reset adaptations followed by a 12 minute tune.
 
I did the ISCV reset and adaptation, should a 12 minute tune be necesary with PCV? The stock O2 sensor is no longer in use.

thanks

Hoopla
 
You were correct sir, seems the 12 minute tune was necesary, probably because I reloaded the 20773 tune from a 20776 tune when installing the PCV,

thanks

Hoopla
 
Back
Top