Ianrocket
Standard Bore
- Joined
- May 9, 2022
- Messages
- 5
- Ride
- Rocket 3
I have a 2006 rocket 3 and the clutch pull arm broke and put a mark/groove in the pressure plate so after reading a few comments on here I ordered from fowlers the pull arm, thrust bearing, washers,pressure plate, and a new arm to go to the cable.
I ordered the newer pull arm and got sent the old one and got a pressure plate that had a hole so big all the bit, pull arm,thrust bearing would fall through if fitted.
The other problem is why is the thrust bearing and washers so big on the pull arm.
I have attached a photo
Any help would be greatly appreciated
I ordered the newer pull arm and got sent the old one and got a pressure plate that had a hole so big all the bit, pull arm,thrust bearing would fall through if fitted.
The other problem is why is the thrust bearing and washers so big on the pull arm.
I have attached a photo
Any help would be greatly appreciated