Doc Roc
Supercharged
Does anyone have a photo of the small disc added to their front brake master cylinder to fix the "lever to the bar" fault?
Front Brake
- Thread starter Doc Roc
- Start date
owl
Turbocharged
It's just a thin washer - nuthin much to photograph, but I'll have a go tomorrow if you want.
Doc Roc
Supercharged
Thanks mate, just can't see what holds it in there.
owl
Turbocharged
Nothing does, other than a slight dollop of grease and the pressure of the node on the back of the brake lever.
Don't do what I did and add three washers at once, thinking it would be even better
On a test run, the brake came on all by itself halfway round a bend :lol:
Don't do what I did and add three washers at once, thinking it would be even better
On a test run, the brake came on all by itself halfway round a bend :lol:
CADFather
Supercharged
Anyone care to enlighten a yank as to what in the bloody 'el you lot are talking about, I've never heard of it. :lol:
owl
Turbocharged
:lol: :lol: :lol: Blueflash put me onto a little trick to improve the front brake - stops it coming right back to the grip, or at least improves it.
Basically, its a thin washer placed between the node on the back of the brake lever and the piston in the master cylinder.
Don't know if a picture is possible, but I'll have a go later.
Basically, its a thin washer placed between the node on the back of the brake lever and the piston in the master cylinder.
Don't know if a picture is possible, but I'll have a go later.
