1 inch grips

[Darron1117]

Hey guy's,

I'm replacing the grips on my 2012 Roadster and have a question.
I wouldn't have to use the throttle cam that comes with the grips, correct or not?
Looks like you just remove the bar ends, cut off old grips and glue new one's on.

Thanks and GO ASTROS !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

 

[scot in exile]

Anytime I have replaced grips the throttle cams were built into the grips

 

[1olbull]

Not necessary to replace the plastic/nylon throttle.
Just cut the rubber off the throttle and left bar then get a set of inexpensive Biltwells:
Easy-Peasy and not costly.

 

[Darron1117]

Thanks,
Do they fit over those many raised tabs on the plastic throttle?

 

[albertaduke]

Thanks,
Do they fit over those many raised tabs on the plastic throttle?

I shaved them down if not you will have a heck of a job to install the grip

 

[Darron1117]

Cool,
Sounds like a mission for the Dremel.

Thanks,

 

[1olbull]

Thanks,
Do they fit over those many raised tabs on the plastic throttle?

Mine did just fine and with no shaving.
After a few years and 30K+ miles, I can see the grip wear in spots relative to the high places of the nylon throttle, but no irregularities are felt while riding.
I have a fresh set of grips ready to replace this winter.

 

[Bondysbike]

Mine did just fine and with no shaving.
After a few years and 30K+ miles, I can see the grip wear in spots relative to the high places of the nylon throttle, but no irregularities are felt while riding.
I have a fresh set of grips ready to replace this winter.

I’m a bit lost...do these simply slide over existing?

 

[1olbull]

I’m a bit lost...do these simply slide over existing?

Once you have cleaned the old grips from the left side bar and the right side throttle - YES!