Search results for query: *

  1. fastfun

    Name Change

    *** In order sorting out the idling/hesitation issue I was adjusting and adjusting. And adjusting in a yeartime.The bike was running one time rather well ,other times back to s*** :banghead: All the time the primary 'behavior 'was looking good,at last the primary replaced , issue gone...
  2. fastfun

    Low miles: clutch gone bad

    If it is a matter of costst for you,cooling fluid you did pull right away from the radiator and is still looking clearly you can put this fluid back into the rad, but pay attention of possible dirtparticles in the fluid. You can use therefore a kind of strainer( a piece of cloth in a funnel...
  3. fastfun

    Low miles: clutch gone bad

    As I have been there in course of time so far, I also have collected some 'extra's'.Precious results of 'try and error'. :banghead: I suggest we swap some extra's with each other :p Steels are still fine. I have a bit bit more than 250 hp so anyway no barnett. :thumbsdown:For a couple of weeks...
  4. fastfun

    Low miles: clutch gone bad

    Tnx :banghead:
  5. fastfun

    Low miles: clutch gone bad

    What about the Barnett fibers ? I already got them but waiting for wintertime installing them. Do I have to regret waisted money ?
  6. fastfun

    Name Change

    Ok.Tnx.
  7. fastfun

    Name Change

    Did you adjust the stepper 'outside', also not attached to the throttlebody ?
  8. fastfun

    hesitation, kicking engine

    Update (18.00 European/Greenwich timetable): Sooow, after a hard day's laptopworking we got still at a sh.... mapping. Especially everytime at the same low rpm range/ throttlemoment :mad: :banghead::banghead: :thumbsdown: Roadtuning is hardly possible and dangerous in this Dutch busy...
  9. fastfun

    hesitation, kicking engine

    Tnx for your response. Yes, the bike runs like ass with a zero setting F-L switch. And also a Yes, we already tried to copy the 2004 TuneEcumap from the Rlll2004 bike but that copying didn't succeed. Even a small F table range from this map didn't the Roadster accept : "not compatible" :mad...
  10. fastfun

    hesitation, kicking engine

    Because my laptopbro went home at our european timetable I contact him again tomorrow. But if I'm correct we were using the F table for Tps setting, without the PcV. I'm belonging to those poor fellers who are convicted to roadtuning and that's as you know, a hell of a job:confused: :( I don't...
  11. fastfun

    hesitation, kicking engine

    So after a day fiddling on the laptop the result : We did set the F-L switch at 0 vacuumline dismantled from map,(put a plug into the line...), However, with F-L set at 0 , AFR drops on to a 20, throttle between 1- 5 %, engine is running sh...:banghead: We tried to set F-TPS as well with PcV...
  12. fastfun

    hesitation, kicking engine

    Ok, tnx Warp. because my laptopbro has his eveningholiday now(european time...):sleep: Tomorrow I will do so at once. I keep you posted.
  13. fastfun

    hesitation, kicking engine

    Hi Warp, tnx for your response.I hope you can help me out of this misery. The bike(Roadster 2010) breathes through an 'old' C30-94. Engine lights are on. I'm using the steppermotor,sec. throttle set at 100%. Steppermotor at 0.71/072. Tps at 0.60 (don't know if Tune-Ecu sets both Tps, prim and...
  14. fastfun

    hesitation, kicking engine

    Update : I just did finish riding the bike without charger running and the bike is running much better in its lower rpm range. Taking that into account TuneEcu/Pc 5 are set at chargerboost FL tablevalues. Could it yet be happening in my life that's the issue ? (= stock mapsensor gets to less...
  15. fastfun

    hesitation, kicking engine

    Tnx for your response Claviger. It is TuneEcu with Pc5, injectors Siemens Deka 80 lb/hr,stock (.) mapsensor, not in gear(s),at slowly roll open Fl table at first shows ok, about 12.issue comes in with riding the bike, under load also.I have an AFR sensor/display on the bike, so at slowly roll...
  16. fastfun

    hesitation, kicking engine

    Tnx motolink. I did that check also but no change.
  17. fastfun

    hesitation, kicking engine

    Hi. I get already for some weeks(.) the next issue : just cruising at nearly idle speed (about 5% throttle) bike is running fine. However, just pulling the throttle from 5 at 10% and the rpm's are inclining at about 1800rpm , the bike suddenly is like 'switching off' and rpm's are declining...
Back
Top