Search results for query: *

  • Users: mr hunt
  • Content: Threads
  • Order by date
  1. mr hunt

    Want to Buy Oil Tank 2300

    Does anyone in Oz have any oil tank for sale? I can source one from Pinwall but would rather shop local if possible
  2. mr hunt

    Oil tank leak

    After repeatedly refitting the oil tank assuming the o-rings weren't seating properly and causing a constant leak from under the tank I noticed that oil was bubbling up around the head of the rear bolt. Removed tank again and.... Neither tank valve is leaking and the seals are fine. Tank and...
  3. mr hunt

    Alternator removal tool

    Does anyone in Oz have the rotor puller available to send to WA?
  4. mr hunt

    Exhaust port colour

    ok experts have at it....(the only clue is the pix are cyl 1 then 2 then 3):
  5. mr hunt

    Stator

    Hunty's roadster needs a new stator...has anyone used anything other than the OEM offering? I see mixed reviews about RM and can't find any other options
  6. mr hunt

    stator replacement

    Following @DEcosse 's very helpful advice in my RR thread it seems that the stator has a ground somewhere and presumably is ****ed. On the plus side i have 2 brand new RR's for sale... ...having been into the R3 guts numerous times I'm of a mind to try and repkace the stator without actually...
  7. mr hunt

    fuel pump sizing

    I have a question by proxy...my little bro is running a stock 2005 gixxer 600 track bike. The fuel pump has tapped out and he is researching replacement options. If the stock unit pumps 120 lpm at a given psi and he gets a new unit that can push 240 lpm at the SAME psi would there likely be any...
  8. mr hunt

    charging system fault

    Ok folks I have a non-charging battery problem. 12.6v across the battery 3 days since bike was last started....so it seems to be holding charge. While cranking volts dropped to 9 - 10 then steady at 12.3 at idle. Holding 2000rpm it took about a minute for voltage to rise to 12.9 Had to stop...
  9. mr hunt

    Thermo fan dead

    Gday punters...got the bike back on the road today. Took some encouragement to fire up and hunted for a while before finding idle (a few backfires and some throttle work). Did a couple of km's (2nd gear 3000rpm max) to prove she is fluid tight - so far so good. I thought the rad fan should have...
  10. mr hunt

    electrical issue...not R3 related

    This is the fan resistor from my ute...it is brand new installed this morning. It worked on all 3 speeds when i tested it (4 speed fan but 4th bypasses the resistor) then clearly it shat itself where that blob of solder is. The resistor sits in the air duct and is cooled by the air passing it...
  11. mr hunt

    hunty goes east

    Gday Victorian's....did i see one of you on Bourke St (Etihad Stadium end) around 2pm today?
  12. mr hunt

    3rd time...

    Finally got hold of the alternator removal tool and split the cases. Id say i was shifting to third from 2nd when the clutch gave way and the result is as you see below... Tall one is 3rd out and short one is 3rd in :(
  13. mr hunt

    Tranny internals

    5th input...first pic is after 50k km's of cruising mixed with flat shifting at 200 (only on a closed circuit of course :whitstling:) 2nd pic is fresh out the packet...how long before i break this one?
  14. mr hunt

    Tranny Rebuild

    A one man job with the right equipment :thumbsup:
  15. mr hunt

    Anyone else...

    ...have this happen... LHS muffler/passenger peg bracket for the uninitiated
  16. mr hunt

    Electrical drama

    From a cold start she fired up as normal. Reversing and turned the bars hard left she cut out. Same again about 20 minutes later pulling in to a car park. Started up fine and I rode home. Seems that I turn the bars left and at a certain point it cuts out. If I swing the bars hard back and forth...
  17. mr hunt

    Aftermarket clutches

    Open question all...I'm about to replace the steels/fibres. OEM delivered to OZ is around AUD700 or about USD500. Looks like I can order a heavy duty set from barrnet or MTC for half that amount. Does anyone have experience with either of these brands or an equivalent?
  18. mr hunt

    Want to Buy Low oil pressure sensor

    Hi All I'm after a low oil pressure sensor - the one at the back of the head....someone forgot to disconnect it when they dropped the engine...:confused: Got no idea what they're worth so if anyone knows what a decent price is please feel free to post :thumbsup:
  19. mr hunt

    Rusty Moose

    Not sure what this bit's actually called - I've always called it the ignition moose for obvious reasons. Just wondering if the rust is common to others? Bike is 4yrs old and ridden all year round so she has seen a fair bit of rain, but the moose has been under the fly screen since about 6months...
  20. mr hunt

    Workshop manual - ABS

    Gday all Does anyone have an electronic copy of the workshop manual for a Roadster? (I assume 2010 onwards). Specifically I want the brake section with info on the ABS system - I have a the generic manual which seems to match up well with the rest of the bike but has no ABS info.
Back
Top