They don't make bars for my bike and they quit making the bike in favor of Indians. Dipsticks. Any Vision rider that says they never dropped one in the tip overs is telling a lie. With full fuel tanks at lower speeds and grab too much front brake they will lay down easily.
 
Last edited:
I had a set lying around for a month or so finally installed them last weekend, as my Brit brother said the company sucks at least the wanker who packs them does and as far as instructions go good luck on that ,takes a few minutes to figure it out if you can do a twelve piece jigsaw puzzle you can install these.
I did use the supplied spindle/ rod that came with it, no need to reroute any cables ,they do look pretty good when on now I do not know about highway pegs as I hold HP in the same high esteem as I do windshields.:D
Thanks, I am concerned with the hardness of the spindle steel. Considering replacing it with a hardened steel aftermarket spindle. I could be overthinking it though!
 
Here you go ,need anymore let me know

IMG_2696.JPG
IMG_2697.JPG
IMG_2698.JPG
IMG_2699.JPG
IMG_2700.JPG
IMG_2701.JPG
IMG_2702.JPG
IMG_2703.JPG

I got my bars installed today. Thx for the pics Scot, especially the one with the spacer. That saved me a bunch of time and headache.... I never seen engine guard be so difficult to figure out. I think I will replace that threaded rod with a hardened steel bolt.
 
What’s the difference between these and dresser bars? These seem like they have and extra bar, In the eBay description at the start it says 38 mm then down the bottom of the description it says 32 mm round tube, what size was yours?

I want to order highway pegs to suit, don’t want To order the wrong size. Doh
Hi everyone, just want to ask does anybody know is there any difference between crash bars for bikes made from 2004-2009 and 2010-2018?
 
Back
Top