warp9.9
Pocałuj mnie w dupę
Thanks warp9.9
No needle just a 5ml syringe. I'll try the job myself & if no good I'll just leave it. I was concerned the diameter might be small enough to block something but couldn't find a diagram to check.
OK let me know I am still looking around I am sure I must have a oil tank I can cut open for a better view but I also can put some pictures together that might help as it is dark inside there and you never get all the oil out from what I can tell.
for instance if you take your fingers and feel under the tank You will find a weld bubble right about in line with the rear opening of the oil plug hole.
Pictures below
The manual does not depict the welded mount for the supply pipe in its picture I have scribbled it in below
inside
sorry about the clarity or lack of it looks better on the scope screen.
also the supply spout curves down at the weld seam of the tank just about between the ****** of my thumb and for finger in the second picture that also would make the center on the seam about the lowest point on the tank. especially when over on the side stand could be wedged between the pipe and the tank side ans you drained it. of course is there air in it or did you just lose the outer part of the syringe?
hope this helps
Last edited: