CamaroCarl
Get busy living or get busy dying.
That's the one. Instead of chopping up my stock fender and bracket, I would be tempted to buy one of these and just bolt it on. 400 bucks and already painted black with red stripes.
What can I do about my azz end?
- Thread starter Dr.D
- Start date
TheKid
Top Fuel
- Joined
- Feb 2, 2011
- Messages
- 1,919
- Location
- Dry Ridge Ky, USA
- Ride
- 2007 Rocket III Standard /2010 R3T
Doc, the one that Dave and I have are simple and work great. Plumb the wiring under the rear fender, solder everything and use shrink tube. I think it was about 200 bucks for front and rear. Make sure you order and change the turn signal relay, for the LED's don't draw enough amperage to operate the stock relay.
TheKid
Top Fuel
- Joined
- Feb 2, 2011
- Messages
- 1,919
- Location
- Dry Ridge Ky, USA
- Ride
- 2007 Rocket III Standard /2010 R3T
Also, there are different types of lighting modes. Mine are only turn signals on the rear. Dave has tail and turn in his. (He is rich). Remind me in MV and I will tell you how I know.
Dr.D
Octane Boost
420ponies
R834YA (bike plate)
I also have the one from EMP . very easy to work with and tightens it all up back there. I also installed "smoke" lens with brighter lamps. works great.
Dr.D
Octane Boost
Dang , that sounds like mental effort and mechanic type work.
I was hoping for an undo two bolts and replace with shorter bolts. Honestly I could manage that except for the soldering . I do not have the tool for that. I might just have to pay a man to do that.BTW Ken if your thinking about criticizing me for being either lazy or stupid maybe when we meet again in MV I can show you how to save some money and work on your own teeth.
Last edited:
scot in exile
Living Legend
BTW Ken if your thinking about criticizing me for being either lazy or stupid maybe when we meet again in MV I can show you how to save some money and work on your own teeth.
Now I will pay good money to see that
Mel buy the goodies and bring it to MV we will get it installed for you, now someone has to stay sober or we might get everything back to front.
Now I will pay good money to see that
Mel buy the goodies and bring it to MV we will get it installed for you, now someone has to stay sober or we might get everything back to front.
Dr.D
Octane Boost
If I don't already have it put on I will bring it. I do hate to press on friends to do projects for me and look pathetic.BTW Ken if your thinking about criticizing me for being either lazy or stupid maybe when we meet again in MV I can show you how to save some money and work on your own teeth.
Now I will pay good money to see that
Mel buy the goodies and bring it to MV we will get it installed for you, now someone has to stay sober or we might get everything back to front.
BTW I'm torn about wether or not I need to re-degree the new cams in my bike. Nev says I could get a better low end torque but I may loose some of the top end hp. I'm going to have mu local guy do a compression check and see what we learn. Wish me luck.
sonny
Living Legend
EMP plate and
front and back
clean and simple.
Longrider
Anywhere ..... just go anywhere!
I had the original one fracture and fall off while on a charity run. This way, when fully loaded there is only one Toll Camera in Australia that gets me .... I know from experience.
Similar threads
