Ignition key relocation

Mittzy

The Hooligan - Just Doing Stuff
Joined
Aug 29, 2011
Messages
8,538
Location
Brisbane, Australia
Ride
2020 TFC #385, 2014 R3 Roadster 230hp (BRUTUS)
I am looking at relocation my ignition on my roadster
But first I want to try to get the later model 8 pin connector so I can make up looms - not just for me but for others too. I can also make the bracket and maybe put a kit together.
As Rivco no longer produces/sells them.

But I need to find where to get these plugs - male and female.

Thanks
 
These are the plugs - Anyone
Les sent me a catalogue that looks promising.
 

Attachments

  • P1050575.JPG
    P1050575.JPG
    43.1 KB · Views: 129
  • P1050576.JPG
    P1050576.JPG
    32.5 KB · Views: 121
  • P1050579.JPG
    P1050579.JPG
    31.1 KB · Views: 118
  • P1050582.JPG
    P1050582.JPG
    50 KB · Views: 118
  • P1050581.JPG
    P1050581.JPG
    30.4 KB · Views: 113
Relocate the key to your belt - do to a digital keyless system. It will cost about $20-30.
 
Well I made a cable up - Works a treat.
Removing the Ign Barrel was a complete PITA, I did as Albertaduke had mentioned - Removing the top section of the triple tree.
This gave me access to install an accessory socket in place of the Ign Barrel.
Pics Below
20140416_090710.jpg
20140416_104159.jpg
20140416_121542.jpg
20140418_215149.jpg
20140422_143426.jpg
20140416_134426.jpg
20140422_151512.jpg
 
The wires are crimped AND soldered.... The rubber water grommets don't go all the way in because it is a fairly crowded plug
 
Back
Top