Search results for query: *

  1. warp9.9

    Hard to get into any gear!

    Is the shifter floppy (more freeplay then normal ) ?
  2. warp9.9

    Engine misses intermittently

    Check clean and recrimp the spade and connector on each low voltage lead to each coil if they are loose they vibrate loose contact and sporadically misfire. Number on coil is the hardest to get to. Also on a few occasions the female spade was so loose it vibrated off the coil. Just a little...
  3. warp9.9

    Starter issues

    He's probably referring to the solenoid rebuild kit. Where all the power transfers. Check the contacts and the contact surfaces on the plunger. Or take the new plunger out of the starter you robbed the motor off of and shorten the spring rod. If you're going to try cleaning the contact area...
  4. warp9.9

    Gearbox - exit stage left - need Robinson info

    I'd give her a try to that looks like its front the fourth gear explosion. After welding I bet some sealant like epoxy for safety wouldn't hurt either.
  5. warp9.9

    Gearbox - exit stage left - need Robinson info

    @Mittzy , are you changing cases or patchin the holes ??
  6. warp9.9

    Odometer +2 ???

    Sounds like you are stuck in a transwarp conduit Cooter ;)
  7. warp9.9

    14 Touring Running Rough

    I was thinking after you cleaned everything and verified the throttle is closing. (You can watch for repeating tps voltage during a few stepper motor tests.) Once you verified the same closing point run a full ISCV reset. And then reset the adaptations.
  8. warp9.9

    RAA

    Ya you guys are some old basturds :)
  9. warp9.9

    Question about classic floorboard controls on roadster

    No issues and you are correct about the brake line. And the R3T board set up works as well.
  10. warp9.9

    Transmission replacement

    Is this in a state the marijuana is legal? Sure sounds like that to me. Personally if you can pull the motor you could do the transmission. It just needed a update kit . When you go look at it see if the cam chain timing is still set. You can split the engine and service the transmission...
  11. warp9.9

    Cam chain guide change

    As long as you monitor it a manual tension will probably last longer because it has more adjustment. If I was switching over I would get one from Neville Lush!! I've had my hands on a few but none as nice or good as Nev's.
  12. warp9.9

    Cam chain guide change

    You can fish the guides up thru the front engine case. I've never done it with the chain still in but the head on and cams in yes. I would like to point out you probably with have to take the cam cover off to set or at least check the timing. I have pulled the cam cover without removing the...
  13. warp9.9

    Rocket 111 GearBox

    Oh ok I was curious as I didn't see anything about the shifter being floppy. I might have missed it because I've been out of play for a while ;)
  14. warp9.9

    Rocket 111 GearBox

    I have to ask since I am just seeing this post. But what nut did you find and where was it located. I didn't see a picture of it.
  15. warp9.9

    Sold my 2021 Rocket 3 GT

    Mel, was this picture taken before you started collecting fancy boots ;)
  16. warp9.9

    Stepper motor regulation problems

    That's great to here you are now a Rocket Scientist !!!
  17. warp9.9

    Stepper motor regulation problems

    all ISCV voltage along with the TPS both primary and secondary are set with the engine switch on so everything is powered up but the engine is not running. You do not have to have power on when changing the stepper motor itself and presetting the .5 mm . Of course if the throttle close is not...
  18. warp9.9

    Sold my 2021 Rocket 3 GT

    I've never had a Triumph fail, mine have had a few problems adapting to off road terrain at slightly elevated speeds. I also found that the rider can travel further once off the bike than the bike can, being it's a fat pig :)
  19. warp9.9

    Stepper motor regulation problems

    The .5 mm gap is just a preset gap when you are installing a stepper motor. Not when one is already on the bike. You just need to do the full ISCV. But first listen to Herman and clean clean, clean. Sound to me like your throttle it sticking and not closing which is why you can reach down there...
  20. warp9.9

    lithium battery

    Bought a lithium battery in 2010 and put it in my airbox. I've gone thru three regular batteries and I still have the same 600cca lithium ferous battery.
Back
Top