[PeteOZ]

I have just received my 2" over clutch from Barnett. As I have not yet received my workshop manual out here in Oz, I want to exercise a little caution. Can I assume it's a standard remove ?
ie, loosen cable at lever, remove clutch lever and unseat cable, then use bottlenose pliers to slip out cable at other end. reverse and readjust freeplay? no gotchas ?

Pete

[Kmutt]

Pete,
See if you can PM Flip n this. I recall a thread where he gave instructions when somebody had an issue with the cable. I would assume if you are removing it completely that this would also apply. I believe their is a preload of sorts, actually its not a preload its a spring tension. But Flip or PIG9R should be able to find it

mutt

[PeteOZ]

[quote=Kmutt;50147]Pete,
See if you can PM Flip n this. I recall a thread where he gave instructions when somebody had an issue with the cable.

Thanks Kmutt. Found a reference to the Flip instructions on the RAT forum.
Pete.