transmission noise!!

fred
I put back the gear position sensor but a doubt came over me !! the plug we bolt on can be mounted two ways 180 degrees from each position and I did not remember which way is right so I put it on with the connecting wire toward the middle of the rear of engine rather than on the outside figuring nobody would want the wire hanging around
Yes Patrick the wire harness goes on the inside pointing towards the center of the engine.
 
Yes Patrick the wire harness goes on the inside pointing towards the center of the engine.
thanks.. I am slowly buttoning her up , I have one loose electric connector that I have not found where is its match(picture 1239 zoom in to check what it is) and my rad covers are falling apart ,the cracks are everywhere old plastic I guess (picture 1240) will try an epoxy solution tomorrow. considering each part is about $75 ,
IMG_1231.JPG
IMG_1233.JPG
IMG_1239.JPG
IMG_1240.JPG
I am not buying plastic at this price
 
thanks.. I am slowly buttoning her up , I have one loose electric connector that I have not found where is its match(picture 1239 zoom in to check what it is) and my rad covers are falling apart ,the cracks are everywhere old plastic I guess (picture 1240) will try an epoxy solution tomorrow. considering each part is about $75 ,
IMG_1231.JPG
IMG_1233.JPG
IMG_1239.JPG
IMG_1240.JPG
I am not buying plastic at this price
Buy Carbon Fibre ones @ $440 (Gulp):banghead:
Fibre Glass Set @ 245 :unsure:
$75 each sounds cheap now:thumbsdown:
http://www.geelongcarboncraft.com.a...rrounds-%2d-Carbon-Fiber%2d-Three-Pieces.html
 
Patrick,
You need to get ahold of the Englishman that makes the awesome stainless rad covers.
I have one and lubbit!!!
Get ahold of @hogweed for more dope, if interested.
 
Message replied to Patrick from this view its hard to tell but if it is from the injector harness then I would say it goes to the idle stepper motor.
 
Wouldn't it be nice if there was a story written about this thread and how much help has been freely forthcoming from forum members instead of revelations about Rockets not being V twins.

Not belittling the contributions from others and the silent support and positive vibes from everyone, @Rocket Scientist and @warp9.9 , you guys rock.
 
Wow Since I have an 05 all this is scary. When I change my oil can I use a magnet to find this material? Hate to pull the pan on a good engine...
 
Back
Top